Solved: Prism jumping out of its position this and then
Solved: LED flickering in the very low dimmer range
Solved: Speed mode fast was active for all effects – must have an effect on Pan/Tilt, only
This is a major update and show critical because focus and zoom settings will be affected and changed!
This update is strongly recommended to use the fixtures in cross rental.
This software may only be installed on devices with the latest hardware version (latest Optical Lens System). If you are not sure if your device meets the latest hardware version, contact GLP Service.
This Firmware can be updated by using the new D3Prog with Firmware 36 or higher as single update – and all drivers coming in one single hex file.
All File-Slots of the D3porg needs to be erased before uploading the single hex file package on the DProg V36 or ff.
Update in sequence – one firmware driver file after the other - can be done with D3Prog Version 31 and ff.
When importing hex files to a d3prog make sure that you choose the correct file type : intel standard file (Hex file) before uploading the files to the programmer
Fixtures can be updated daisy chain via DMX. Please make sure that no other DMX receivers or consoles are active on the line.
Capture Manual DMX Settings and use as Stand-alone or instead DMX Hold
Color/Gobo Shortway: In some circumstances C/G shortway was not working correctly
Movement disabled during working in the display menu improved. Movement will restart with 3s delay after returning back to DMX address.
Main and Effect driver have to be updated in sequence.
When importing the 2 hex files to a d3prog please make sure that you choose the file type Intel standard file ( Hex- file) before uploading the files to the programmer.
Fixtures can be updated daisy chain via DMX. Please make sure that no other DMX receivers or consoles are active on the line