GLP Tech News 2023/07/21 [impression X5 IP Bar 1000]

GLP Tech News 2023/07/21 [impression X5 IP Bar 1000]
GLP Logo

‍Tech News - 2023/07/21

Dear ,

Please find important technical information below.

Many thanks in advance for your kind attention.

GLP impression X5 IP Bar 1000

Main changes from V1.1.3 to V1.1.5


Because of an added filter holder frame to the impression X5 IP Bar, the tilt speed has to be adjusted with this software update: Tilt speeds for Performance Mode "Smooth", "Normal" and "Fast" were adjusted for best performance.

"Normal" speed is minimal decreased for a save perfomance with installed filter.

"Fast" speed is adjusted to max. speed for use without installed filter.




Fixtures need 1 update, if V1.0.1 or higher is installed already.


Via D3Prog (RS485/DMX):

1. Update the Main Application V 1.1.5 via DMX/RS485 via D3Prog (impression-X5_1.1.5_DMX.bin)


Optional via iQ.Service App (no Login needed) :

Change the Control Protocol in the Fixtures Protocol Setup Menu to iQ.Mesh,

or via DMX Control Channel to iQ.Service Connect: DMX 012-013 (4,7% - 5,1%)


1. Update the Main Application V 1.1.5


Please make sure that no other DMX receivers or consoles are active on the line

and fixtures Control Protocol is set to DMX!


This update is show critical as the tilt speed is changed to work with the added filter holders and optional filters.

This update is an important update that should be installed to prevent device errors


impression-X5_1.1.5_DMX.bin (provided via website as download and iQ.Service App)


This Newsletter was sent on Thursday, 25 April 2024 10:22 ‍ by ‍GLP German Light Products GmbH, All rights reserved. You are receiving this newsletter because you have either ordered it on the website or have a business relationship with GLP (or both).