GLP Tech News 2020/10/02

GLP Tech News 2020/10/02
Open in Browser


Tech News - 2020/10/02

Dear ,
please find important technical information for fixture software updates as below.
Many thanks for your kind attention in advance.

GLP delivers the impression FR10Bar from now on with Version 24

Main changes from V20 to V24


  • Added: Service Mode: hold menu button 1 and 4 for 3 seconds while booting will power off the tilt motor.


  • Resolved: RDM Device Label was not displayed correctly
  • Resolved: Pattern transition function affacts change behaviour from step to step within a single pattern by mistake
  • Resolved: Shutter Random Single Pixel was not random


Update can be done with D3Prog Version 42 or higher.
When importing the bin file into a D3Prog please make sure that you choose the file type BIN before uploading the files to the programmer.

Fixtures can be updated daisy chain via RS485/DMX. Please make sure that no other DMX receivers or consoles are active on the line.


GLP impression FR10 Bar Firmware V24 Rev20200930 ( zip | 287.22 KB)

Copyright © 2023 GLP German Light Products GmbH, All rights reserved. You are receiving this newsletter because you have either ordered it on the website or have a business relationship with GLP (or both).

You no longer want to receive our news? - Unsubscribe